Gema OptiGun GA03-E, Operating Instructions And Spare Parts List, Page: 27 / 45

V 02/22
OptiGun GA03-E Cleaning and maintenance
•
25
Maintenance
The gun is designed to require only a minimum amount of maintenance.
1. Clean the gun with dry cloth, see chapter "Maintenance"
2. Check connection points to powder house.
3. Replace the powder hoses, if necessary.
Replacing parts
Except for the replacement of possible defective parts, there are very few
repairs to be made.
The replacement of the cascade and the repair of the powder gun
cable connection is only permitted by an authorized Gema Ser-
vice center!
– Contact your Gema representative for details!
Dismantling the gun
General information
The gun should only be dismantled, if this is required because of
a defect or pollution.
– Dismantle the gun only so far, as the desired part is accessible!
WARNING
Touching the gun parts
During work on the gun, the gun can discharge along the body of
the coater if touching it.
► Before dismantling the gun, switch off the control unit and discon-
nect the gun plug!