GEM 649 eSyDrive, Operating Instructions Manual

Page: 35 / 48

www.gemu-group.com 35 / 48 GEMÜ 649 eSyDrive
NOTICE
Connector elements
▶
The connector elements are not included in the scope of
delivery.
●
Only use connector elements made of approved materi-
als.
●
Observe permissible tightening torque of the bolts.
1. Keep sealing material ready.
2. Carry out preparations for installation (see chapter "Pre-
paring for installation").
3. Ensure clean, undamaged sealing surfaces on the connec-
tion flanges.
4. Align flanges carefully before installing them.
5. Clamp the product centrally between the piping with
flanges.
6. Centre the gaskets.
7. Connect the valve flange and the piping flange using ap-
propriate sealing materials and matching bolting.
8. Use all flange holes.
9. Tighten the bolts diagonally.
10. Re-attach or reactivate all safety and protective devices.
15 Electrical connection
NOTICE
Appropriate cable socket/appropriate mating connector!
▶
The appropriate cable socket and/or appropriate mating
connector is included for X1, X3 and X4.
▶
The appropriate cable socket and/or appropriate mating
connector is not included for X2.
X3
X2
X4
X1
Fig. 12: Overview of electrical connections
15.1 Connection X1
1
3 2
6
5
4
7-pin plug, Binder, type 693
Pin Signal name
Pin 1 Uv, 24 V DC supply voltage
Pin 2 Uv GND
Pin 3 Relay output K1, common
Pin 4 Relay output K1, make contact
Pin 5 Relay output K2, common
Pin 6 Relay output K2, make contact
Pin PE Function earth
15.2 Connection X2
1 5
4
3
2
5-pin M12 built-in socket, D-coded
Pin Signal name
Pin 1 Tx + (Ethernet)
Pin 2 Rx + (Ethernet)
Pin 3 Tx - (Ethernet)
Pin 4 Rx - (Ethernet)
Pin 5 Shield
15.3 Connection X3
6
5
3
2
4
7
8
1
8-pin M12 plug, A-coded
Pin Signal name
Pin 1 I + set value input
Pin 2 I – set value input
Pin 3 I + actual value output
Pin 4 GND (actual value output, digital input 1 – 3, er-
ror message output)
Pin 5 Error message output 24 V DC
Pin 6 Digital input 3
Pin 7 Digital input 1
Pin 8 Digital input 2
15 Electrical connection