Gehl R135, Operator'S Manual

Page: 157 / 206

153 50940193/DP0415
. Battery
Before servicing the battery or electrical system,
be sure the battery disconnect switch (if equipped)
is in the OFF position. If not equipped with a disconnect switch,
disconnect the ground (-) terminal from battery.
The battery on the loader is a 12-volt, wet-cell battery. To access the battery, remove front
floor panel.
The battery top must be kept clean. Clean it with an alkaline solution (ammonia or baking
soda and water). After foaming has stopped, flush the battery top with clean water. If the
terminals and cable connection clamps are corroded or have a build-up, disconnect the
cables and clean the terminals and clamps with the same alkaline solution.
Explosive gas is produced while a battery is in use
or being charged. Keep flames or sparks away
from the battery area. ALWAYS charge the battery in a well-ventilated
area.
Never lay a metal object on top of a battery, because a short circuit can
result.
Whenever the battery is removed, be sure to disconnect the negative (-)
battery terminal connection first.
Battery acid is harmful on contact with skin or fabrics. If acid spills,
follow these first-aid tips:
1. Immediately remove any clothing on which acid spills.
2. If acid contacts the skin, rinse the affected area with running water
for 10 to 15 minutes.
3. If acid contacts the eyes, flood the eyes with running water for 10 to
15 minutes. See a doctor at once. Never use any medication or eye
drops unless prescribed by the doctor.
4. To neutralize acid spilled on the floor, use one of the following
mixtures:
a. 0.5 kg (1 lb.) of baking soda in 4 L (1 gal.) of water.
b. 0.5 L (1 pt.) of household ammonia in 4 L (1 gal.) of water.
WARNING
WARNING