Gehl GE 802, Operator'S Manual

Page: 42 / 52

PRINTED IN U.S.A.
4-12
90 8147 /0999
HYDRAULIC SYSTEM
1. Position the machine on a level surface.
2. Fully extend the bucket and boomas shown (Figure 4-
12). Lower bucket and dozer blade to the ground. Turn
off the machine.
3. Remove the hydraulic valve cover as shown (Figure 4-
12).
3. Check the hydraulic oil level indicator. Oil level should
be between black and red marks on sight glass. If
hydraulic oil is required, proceed to step 4.
4. Slowly open the hydraulic oil cap to relieve pressure,
then remove cap.
5. Add hydraulic oil until oil level is between red and black
marks on indicator (Figure 4-12).
6. Re-install hydraulic tank cap and tighten securely.
7. Start engine and let idle for a few minutes.
8. Check hydraulic functions. Recheck hydraulic oil level.
Checking Hydraulic Oil Level
Figure 4-12. Checking Hydraulic Oil Level
Sight Glass
WARNING
Hydraulic reservoir is under pressure. Avoid
contact with leaking hydraulic fluid or diesel
fuel under pressure. It can penetrate the skin
or eyes and cause severe injury.