gefran TPD32-EV-...-2B, Instructions Manual

Page: 492 / 504

—————— TPD32-EV ——————
492
A2.4 Digital Outputs
This section modifies chapter "6.12.3 Digital Outputs" on page 216.
• Added selections needed for “
Ext wired FC
”:
Digital output XX Selection of the parameter that is assigned to the digital output concerned. The following
assignments are possible:
OFF
Speed zero thr
Spd threshold
Set speed
Curr limit state
Drive ready
Mot ovrld avail
6)
Overload state
Ramp +
Ramp -
Speed limited
Undervoltage
Overvoltage
Heatsink
Overcurrent
Overtemp motor
External fault
Failure supply
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Pad A bit
Pad B bit
Virt dig input
Torque sign
Stop control
Field loss
Speed fbk loss
Bus loss
Hw opt1 failure
Opt2 failure
Encoder 1 state
Encoder 2 state
Enable seq err
Diameter calc st
1)
Drive healthy
13)
Input 1 cp match
Diam reached
Spd match compl
18
19
20
21
23
24
25
26
28
29
30
31
35
38
42
49
58
59
Acc state
Dec state
Brake comand
2)
Brake failure
3)
Mot ovrld preal
4)
Dvr ovrld preal
5)
Dvr ovrld avail
7)
I2t mot ovrld fail
8)
I2t drv ovrld fail
9)
Mot cur threshld
10)
Overspeed
11)
Delta frequency
12)
Drv rdy to start
14)
BUS control mode
15)
SSC Error
16)
60
61
62
63
65
66
67
68
69
70
71
72
76
77
79
Wired FC Enabled
17)
Wired FC Inv Seq
18)
Wired FC Act Brg
19)
80
81
82
17)
Enables field control by TPD32-EV-FC via standard I/O.
18)
Indication if field control is during inversion sequence
19)
Indication of the actual active bridge (positive or negative) of the FC unit.
n
ote
:
For the operation of the FC unit by using external I/O signals, the three digital outputs of the
FC unit, configured as indicated in section "A2.5.2 Connection between TPD32-EV-CU and
TPD32-EV-FC units via external I/O" on page 495, must be connected to the digital inputs
of the CU configured in the same way. In addition, the analog output of the CU configured
as " Field cur ref " must be connected to an analog input unit configured as FC " T current
ref 1 ."