gefran ADV200 WA, Functions Description And Parameters List

Page: 68 / 300

68
ADV200 WA • Functions description and parameters list
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.4 2006 Rated frequency Hz FLOAT SIZE 10.0 1000.0 RWZS VS
Rated frequency of the motor expressed in Hz, at which the flux weakening range starts.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.5 2008 Pole pairs UINT16 SIZE 1 20 RWZS VS
Motor pole pairs. The number of motor pole pairs is calculated using the motor plate data and applying the
following formula:
60 [s] x f [Hz]
P =
nN [rpm]
Where:
p = motor pole pairs
f = motor rated frequency (P. 2006)
nN = motor rated speed (P. 2004)
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.6 2010 Rated power kW FLOAT SIZE 0.1 1500.0 RWZS VS
Rated power of the motor at the rated voltage and frequency. This value represents the mechanical power
produced on the motor shaft.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.7 2012 Rated power factor FLOAT SIZE 0.6 0.95 RWZS VS
Motor power factor, as indicated on the data plate (Cos j ). This parameter is not always present on the motor
data plate: in that case use the default value present in the drive.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.8 2020 Take parameters BIT 0 0 1 RWZ VS
Saves the set motor data in the drive. This command must be supplied last after entering the appropriate
values of all the parameters listed above. This means calculating the normalization factors (a) and estimated
values for the motor parameters (b). The drive cannot be started until the Take parameters command has
been set.
Note ! This is not saved permanently. Use the “ Save Parameters ” command in the DRIVE CONFIG menu to save in the permanent
memory.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.9 2022 Autotune rotation BIT 0 0 1 RWZ VS
Performs self-tuning in rotation: the motor must be uncoupled from the load or the transmission must not
represent more than 5% of the load. This procedure allows the greatest degree of accuracy in measuring
the motor parameters. To execute the command you must first open the hardware enabling contact between
terminals 7 and S3. Next set the Regulation mode parameter to Autotune . If you are not already in Local
mode, press the Local key (the
LOC
LED will light up) and close the hardware enabling contact again (termi-
nals 7 and S3). Selt-tuning can now be performed. At the end of the self-tuning procedure, open the contact
between terminals 7 and S3 again and reset the parameters that were modified.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
16.10 2024 Autotune still BIT 0 0 1 RWZ VS
Performs self-tuning with the motor coupled to the transmission. The self-tuning procedure may cause limited
rotation of the motor shaft. To perform self-tuning, follow the procedure described for the previous parameter.