gefran ADV200 WA, Functions Description And Parameters List, Page: 34 / 300

34
ADV200 WA • Functions description and parameters list
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
8.12 892 Mpot mode ENUM Fine&Last val 0 3 ERW VS
Setting of the configuration of two possible options of the Motor potentiometer function. There are two operat-
ing modes for each of the two options.
0 Ramp&Last val
1 Ramp&Follow
2 Fine&Last val
3 Fine&Follow
Option 1: Behaviour of the Motor potentiometer function with the Stop or FastStop command present with the
Control mode = Ramp parameter.
The two operating modes are: Last val or Follow .
With the Control mode not equal to Ramp setting, this option is not completely applicable and it always be-
haves in Last val mode.
In Last val mode with the Stop or FastStop command present, the speed reference of the Motor potentiom-
eter function is not altered.
The motor speed moves to 0 according to the selected control mode (
Control mode = Ramp or Control
mode = Speed
). When the Run command is sent, the motor speed moves to the speed reference set by the
motor potentiometer function according to the selected control mode.
Up
Down
Mpot output mon Mode:Last val
Start
In Follow mode with the Stop or FastStop command present, the Down command is simulated, i.e. the output
of the Motor potentiometer function moves to 0 with the set ramp time.
If the Run command is sent when the 0 speed has been reached, it is maintained until the Up command is
sent. If the Run command is sent before the motor reaches the 0 speed, the speed at that moment is taken as
the new reference.
Up
Down
Monitor uscita Mpot Mod.:Seguente
Start
Option 2: Ramp behaviour
The two operating modes are: Ramp or Fine
In Ramp mode, each time the Up or Down commands are enabled, the output of the Motor potentiometer
function increases or decreases with the set ramp. When the Up or Down command is removed, the last
value that was reached is maintained.