gefran ADV200 WA, Functions Description And Parameters List

Page: 16 / 300

16
ADV200 WA • Functions description and parameters list
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
4.4 556 Control mode select ENUM Ramp 0 2 ERWZ _S
Selection of the drive control mode.
0 Torque
1
Speed
2 Ramp
In
torque control (0 - Torque)
the reference and load of the motor determine its speed and direction of rota-
tion. Symmetrical torque limits can be set, for each direction of rotation and for motor/generator operation.
In
speed control (1 - Speed) the reference arrives straight after the ramp circuit, enabling an extremely rapid
response to signal variations. This is ideal for applications that require a highly dynamic response. This type of
control is available in the Flux vector OL control mode. In this mode the Ramp function is not used to gener-
ate the drive speed reference so it can be used in stand-alone mode.
In control with ramp (2 - Ramp) the speed reference is applied to the input of the “ Ramp ” block and is pro-
duced by the “ Ramp ref ” block. This allows setting of both the acceleration/deceleration times and the ramp
time (linear or S-shaped with customizable jerks). This type of control is available in all control.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
4.5 558 Application select ENUM None 0 2 ERWZ VS
Selection of which IEC 61131-3-compliant application.
0 None
1 Application 1 ( Macro , see menu 27)
2 Application 2 ( Multidrive , see menu 27)
The drive is supplied already incorporating a number of applications developed in the IEC 61331-3 environ-
ment. To use these, set the desired application, run Save parameters, switch the drive off and then on again.
NOTE!
The Load Default command (par. 580) does not modify this parameter
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
4.6 560 Mains voltage ENUM 400 V SIZE SIZE ERWZS VS
Setting of the available mains voltage value in Volts. Detection of the undervoltage alarm refers to this value.
0 None
1
230 V
2 380 V
3 400 V
4 415 V
5
440 V
6 460 V
7 480 V
8 500 V
9 575 V
10 690 V
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
4.7 586 DC supply ENUM None 0 7 ERWZS VS
Selection of the voltage applied to the DC link if the drive is powered by an AC/DC power supply unit, whether
normal or regenerative (e.g. AFE200). If a value of other than “None” is selected, parameters that depend on
parameter 560
Mains voltage
are calculated on the basis of the voltage shown in the table below, while the
value of parameter 560 Tensione di rete is set automatically.
If “None” is selected, these parameters are calculated according to the value of parameter 560
Mains voltage .