gefran ADV200 WA, Functions Description And Parameters List, Page: 131 / 300

ADV200 WA • Functions description and parameters list
131
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.60 7722 Dry pump delay s UINT16 30 1 3600 RW VS
Setting of the delay after which, if conditions remain unchanged, the Dry pump alarm is activated.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.61 7726 No flow activity ENUM Warning 0 4 RW VS
Setting of the behaviour of the drive if the Dry pump alarm is present. The No flow alarm is activated if the
power delivered is below the threshold calculated for the minimum power curve.
0 Ignore
1 Warning
2 Disable
3 Stop
4 Fast stop
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.62 7728 No flow delay s UINT16 30 1 3600 RW VS
Setting of the delay after which, if conditions remain unchanged, the No flow alarm is activated.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.63 7808 Clean alm num cycles UINT16 1 1 100 RW VS
Setting of the number of consecutive cleaning cycles performed close together that generate the alarm.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.64 7810 Clean alm thr time rpm INT16 0 0 8760 RW VS
Setting of the Clean alarm time. If the time between two cleaning cycles is shorter than this time, the alarm
counter is increased. The alarm is activated when the counter reaches the limit set in parameter 7808 Clean
alm num cycles . The counter is reset even if the interval is only longer than this time once.
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.65 7812 Clean activity ENUM Warning 0 4 RW VS
Setting of the behaviour of the drive in case of an alarm indicating too many cleaning cycles.
0 Ignore
1
Warning
2 Disable
3
Stop
4 Fast stop
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.66 7816 Analog 1 err act ENUM Ignore 0 4 RW VS
Setting of the behaviour of the drive if the measurement error alarm is present on analog channel 1. If an
analog measurement is out of the allowed range an Analog x err alarm is generated. This control is only pos-
sible for 4-20 mA, PT100, PT1000, NI1000 probes. For temperature probes both short-circuits and power loss
on the cable are detected.
For the 4-20 mA only power loss on the cable is detected.
0 Ignore
1 Warning
2 Disable
3 Stop
4
Fast stop
Menu PAR Description UM Type FB BIT Def Min Max Acc Mod
24.67 7818 Analog 1 err delay s FLOAT 1 0.1 60 RW VS
Setting of the delay after which the alarm is activated.