GEFRAN-SIEI ARTDrive Vector V2 400Vac Series, Instruction Manual

Page: 88 / 387

88 • Chapter 5 Quick Start Up Guide ARTDrive V2 series - Instruction Manual
5.5.1 Motor Potentiometer and Jog
Run the motor using Motopot function
This function is enabled in the standard settings with a Speed Reference value
= 1000rpm.
N
OTE
!
Verify
B STARTUP / B01 Main cmds / B01.00 - Command select
=
[4] I/O
keys
.
To run
the motor using Motopot function connect terminal 12 (Enable), terminal
13 (Start), to terminal 19 (+24VDC) through relays or local switch and follow the
steps in the table below:
How to use Jog function
This function is enabled in the standard setting with a speed reference value =
100 rpm.
Connect terminal 12 (Enable) and 13 (Start) to terminal 19 (+24VDC) through
relays or local switch.
Press
[SHIFT]
and
[+]
to run, the speed will be displayed
Press
[-]
to change the motor shaft rotation
Press
[Jog]
to run the other direction
Press
[Left]
to exit from jog operation
To change the jog speed reference, edit the reference in the following menu
path:
D REF&RAMP / D10 Jog / D10.10 - Jog speed 1
N
OTE
!
“Full” Access level to the drive parameters is required
Press to save the settings if required.
Control buttons Sequencing
Press START button to command the Drive to the
Enable and Run state
Press STOP button commands to stop the Drive from
the Run state
Press to display the speed reference value and to
increase the reference value and accelerate the drive.
Press to decrease the reference value and
decelerate the drive.
Press SHIFT and [-] to change the motor shaft rotation
Display example after pressing
R: 0 S: 0
STATUS
R: 0 S: 0
STATUS
Mpot output mon
320 rpm
Mpot output mon
-150 rpm
Mpot output mon
150 rpm
Jog
S hift