GEFRAN-SIEI ARTDrive Vector V2 400Vac Series, Instruction Manual

Page: 16 / 387

16 • Chapter 2 Inspection Procedure,... ARTDrive V2 series - Instruction Manual
Chapter 2 - Inspection Procedure, Component Identification and
Standard Specification
2.1 Upon Delivery Inspection Procedures
2.1.1 General
A high degree of care is taken in packing the AVy Drives and preparing them for
delivery. They should only be transported with suitable transport equipment (see
weight data on tables 3.1.1 and 3.1.2). Observe the instructions printed on the
packaging. This also applies when the device is unpacked and installed in the
control cabinet.
Upon delivery, check the following:
- the packaging for any external damage
- whether the delivery note matches your order.
Open the packaging with suitable tools. Check whether:
- any parts were damaged during transport
- the device type corresponds to your order
In the event of any damage or of an incomplete or incorrect delivery please
notify the responsible sales offices immediately.
The devices should only be stored in dry rooms within the specified temperature
ranges .
N
OTE
! A certain degree of moisture condensation is permissible if this arises from
changes in temperature (see section 2.3.1, “Permissible Environmental
Conditions”). This does not, however, apply when the devices are in operation.
Always ensure that there is no moisture condensation in devices that are
connected to the power supply!
2.1.2 Inverter Type Designation
The technical specification of the AVy Drive is stated in the type code. Example:
Figure 2.1.2.1: Inverter Type Designation
X
[-4] -5
= software
= 230/480Vac series, =575Vac series
standard
X = NOT integrated braking unit , B = Integrated braking unit
X = KCS led module, K = programmable KBS ke y pad
Drive kW or HP (-5 series) rating
Drive mechanical dimension
ART Drive series
AVy1030-XXX-5
The AVy Drive selected depends on the rated current of the motor. The rated
output current at the appropriate service conditions must be greater than or
equal to the motor current required.
The speed of the three-phase motor is determined by the number of pole pairs
and the frequency (nameplate, data sheet) of the motor concerned. Operation
above the rated frequency and speed of the motor must take into account the