GEFRAN-SIEI ARTDrive Vector V2 400Vac Series, Instruction Manual

Page: 109 / 387

Index
MENU MENU
MENU MENU
MENU
[Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 109
B STARTUP
The drive can control the motor in three different ways: V/f (VF), Field Oriented (FOC)
and Sensorless vect (SLS).
Start the process for the motor data automatic measuring.
•
Automatic calculation of the flux and current loop gains according to the performed
measuring processes.
•
Setting of the information about:
- maximum speed
- configuration of the V/f mode.
- drive parameters (mains voltage, ambient temperature, etc.)
- motor parameters
- inverter main commands
- inverter main reference
- motor/inverter ramp times
- encoder features, if used.
- parameters of the I2t protections.
Such settings can be changed only with a disabled drive. While in this operation mode
(Configuration) the data updating on the terminal strip and on the option cards is stopped.
B00 STARTUP / Drv & Mot config
After downloading drive parameters from a file, or entering the
STARTUP / Drv & Mot
config
menu through the keypad, the drive restart is only permitted after:
a) cycling drive power
or:
b) when
Commands
select =
Terminal level,
cycling input DI0,
when
Commands
select =
Terminal edge
, cycling input DI0, and the digital input
selected by
Term strstp src
,
when
Commands
select =
Digital level
, cycling the digital signals selected by
Digital strstp src
and
Digital enable src
when commands select =
Digital edge
, cycle input DI0 or the digital input
Digital
enable src
(if not selected to ONE), and the digital signal selected by
Digital
strstp src
.
It allows to select the desired regulation mode. After choosing the setting, the Drive
carries out the restart phase by setting the selected regulation mode.
B0A STARTUP / Drv & Mot config / Regulation mode
B0A.00 Regulation mode N/A R 0 0/7 DK V-F-S Easy 100
It allows to select the desired regulation mode. When the
Regulation mode
parameter is
selected, the active regulation mode is displayed; in order to change it to a new mode
press “Enter”; then scroll the list:
[1] V/f control V/f scalar control
[2] FOC control Field Oriented control
[3] SLS control Sensorless control