page | 30
Command Defaults
UDP Configuration
1.
Configure the desired control system for UDP.
2.
Click the Network tab, within the web interface, and do the following. See
Network
Configuration using Syner-G
, for more information.
h
Click the
Enabled
button next to UDP Access.
h
Enter the UDP listening port in the UDP Port field. The default UDP listening port is 23.
h
Click the
Enabled
button next to Remote UDP Access. This feature only needs to be
enabled if feedback to the matrix is required. Otherwise, this feature can be disabled.
h
If enabling Remote UDP Access, enter the remote UDP IP address in the Remote UDP IP
Address field. This IP address should be the same as the control system. The default IP
address is 192.168.0.71.
h
If enabling Remote UDP Access, enter the remote UDP listening port in the Remote UDP
Port field. The default remote UDP listening port is 23.
h
Click the
Save
button at the bottom of the Network screen.
