Connect the VGA RS232 Extender sender unit to the VGA and RS232 output on
the back of your computer. The six foot RS232 and M-F VGA cables connect the
CPU and sender unit together.
Connect the VGA RS232 Extender receiver unit to your monitor with the VGA cable
that is attached to your monitor.
Connect the VGA RS232 Extender receiver unit to your RS232 device.
Connect the CAT5 cable between the VGA RS232 Extender sender and receiver’s
CAT5 input.
Plug the 5 volt power supplies into both the sender and receiver unit.
NOTE: The Brightness trim pod “B” can be adjusted to change the brightness of
the picture.
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
5.
4