Gefen EXT-UHDV-KA-LANS-RX, User Manual, Page: 57 / 188

page | 45
Active on link mode
Under Active on link mode, a maximum of four USB devices can be used within a system.
In the diagram, on the previous page, the system is already using the maximum number of
USB devices (2 USB devices per Receiver). If we had two more Receiver units (making
a total of four Receiver units), we would only be able to connect one USB device to each
Receiver unit. To switch to Active on link mode, follow the instruction below.
1. Access the Web interface for the Sender unit.
2. Login as “Administrator”.
3. Click the Functions tab.
4. Locate the USB over IP group and make sure the Enable USB over IP box is
checked. This is the default setting.
5. Click the Active on link radio button within the USB over IP group.
6. Click the Apply button within the USB over IP group.
7. The following message will be displayed, at the top of the page, indicating that the
new Serial over IP options have been applied.
8. Click the Reboot button at the bottom of the page. If the Reboot button is not clicked,
the following message will be displayed, indicating that the unit must be rebooted.
9. Repeat steps 2 - 8 for the Receiver unit.
B
asic Oper
ation
USB Control