Gefen EXT-UHDV-KA-LANS-RX, User Manual, Page: 43 / 188

page | 31
3. Click the Network tab.
4. Click the Multicast button under the Network Mode window group. When selected,
the
Multicast
button will be highlighted in blue.
5. Click the Apply button in the lower-right corner of the Network Mode group.
The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
If a display is connected to the Receiver unit, then the message “Starting USB”
will be displayed. For more information on using USB under multicast mode,
see USB under Multicast Mode (page 41 ) .
6. Click the Reboot button at the bottom of the page. If the Reboot button is not clicked,
the following message will be displayed, indicating that the unit must be rebooted.
7. Repeat the steps above in order to configure the Sender unit to multicast mode.
B
asic Oper
ation
Unicast & Multicast Modes
Important
When switching between
unicast
and
multicast
modes, both Sender and
Receiver units must be set to the same mode.