Gefen EXT-UHD600A-88, User Manual

Page: 74 / 232

page | 62
B
asic Oper
ation
B
asic Oper
ation
Menu System
Setting the Matrix IR Channel
Use this menu option to set the IR channel of the matrix. In order for the included IR
remote to work with the matrix, both the matrix and the IR remote control must be set
to the same IR channel. See Setting the IR Channel (page 9) for more information on
setting the IR channel for the IR remote control.
1. Go to the routing screen . If the routing screen is not displayed, then press the
Back button on the front panel or on the IR remote control until the routing screen
is displayed.
2. Press and release the Menu button on the front panel or on the IR remote control.
The Menu button, on the front panel, will momentarily flash blue when it is pressed.
3. The Setup menu will be displayed:
4. Press and release the ▲ or ▼ buttons on the
front panel or on the IR remote control,
to select the System menu:
5. Press the Enter button on the front panel.
If using the included IR remote control, press the
OK button.
6. Press the ▲ or ▼ buttons on the front panel
or on the IR remote control to select the IR
Channel menu.
The current IR channel will be displayed.
setup
System OK
Output
RMT-88A
Menu
Back
Down
Up
OFF 1
3
5 6
7
Input
8
4
2
Preset
Mask
Lock
A B
Power
C D Mute
E F Volume
G H
R0
3,1.5V
R0
3,
1.5V
ON
1 2
®
Back
Enter
IR Power
Menu Preset
Lock
4K 60 Hz 4:4:4, HDMI 2.0, HDCP 2.2
Reset
Ultra HD 600 MHz 8x8 Matrix w/HDR and Audio De-Embedder
RS-232
IP Control IR In/Ext
EXT-UHD600A-88
Out A
L/R L/R L/R L/R L/R L/R L/R L/R
In 1
Out B Out C Out D Out E Out F Out G Out H
In 2 In 3 In 4 In 5 In 6 In 7 In 8 24V DC
SETUP
B
asic Oper
ation
B
asic Oper
ation