Gefen EXT-UHD600A-88, User Manual

Page: 55 / 232

page | 43
IP Settings
Use this menu option to set the IP mode, IP address, subnet mask, gateway, and HTTP
port of the matrix.
1. Go to the routing screen . If the routing screen is not displayed, then press
the Back button on the front panel or on the IR remote control until the routing screen
is displayed.
2. Press and release the Menu button on the front panel or on the IR remote control.
The Menu button, on the front panel, will momentarily flash blue when it is pressed.
6. Press the Enter button on the front panel or the OK button on the IR remote control
to display the IP Mode screen. The current network mode will be displayed.
OK
Output
RMT-88A
Menu
Back
Down
Up
OFF 1
3
5 6
7
Input
8
4
2
Preset
Mask
Lock
A B
Power
C D Mute
E F Volume
G H
R0
3,1.5V
R0
3,
1.5V
ON
1 2
B
asic Oper
ation
B
asic Oper
ation
Menu System
2. The Setup menu will be displayed:
3. Press and release the ▲ or ▼ buttons on the
front panel or on the IR remote control,
to select the Network menu:
4. Press the Enter button on the front panel.
If using the included IR remote control, press the
OK button.
5. The IP Settings menu will be displayed:
setup
network
ip settings
®
Back
Enter
IR Power
Menu Preset
Lock
4K 60 Hz 4:4:4, HDMI 2.0, HDCP 2.2
Reset
Ultra HD 600 MHz 8x8 Matrix w/HDR and Audio De-Embedder
RS-232
IP Control IR In/Ext
EXT-UHD600A-88
Out A
L/R L/R L/R L/R L/R L/R L/R L/R
In 1
Out B Out C
Out D
Out E
Out F
Out G
Out H
In 2 In 3 In 4 In 5 In 6 In 7 In 8 24V DC
SETUP