5
SENDER UNIT LAYOUT
1 Power
Indicator
This LED will turn RED once the locking power supply has been properly
connected. When the CAT-5 link is established between the Sender and
Receiver units, the LED will be GREEN. When the Sender unit is in Standby
Mode or Power Saving Mode, this LED will be RED. (Power Saving Mode is
covered in detail on page 9).
2
5V DC Locking Power Connector
Connects the included 5V DC Locking Power Supply to this receptacle.
3
VGA Input (HD15 Connector)
Connect the VGA source to this port.
4
Local Monitor Output (HD15 Connector)
Connect a VGA monitor to this port.
5
Audio Input Connector (3.5mm Mini-Stereo)
Connect analog audio here via a 3.5 mm audio jack.
6
CAT-5 Video Output Jack (RJ-45 Connector)
Connects the Sender unit to the Receiver Unit using CAT-5 cable. Used to
extend the video signal to the Receiver Unit.
7
USB Input Port (USB type “B”)
Connect a Computer or USB device to this port.
8 Host
Indicator
This LED will turn GREEN when the power and all devices are connected to
the Sender unit. The LED will turn RED if a USB device or monitor has been
disconnected from the Sender unit.
9
CAT-5 USB Link Output (RJ-45 Connector)
Connects the Sender unit to the Receiver unit using CAT-5 cable. Used to
extend the USB device from the Sender Unit to the Receiver Unit.