1
2
3
4
5
6
7
8
Starting and Driving
111
Lock and Unlock
Remote Control
The remote control can only work within the
certain range. Pay attention that the work-
ing range is sometimes affected by the
physical, geographical and other factors.
For the safety, when you want to lock the
vehicle door with the remote control, please
check whether the operation is effective.
Keyless Entry System
Keyless Unlocking
So long as there is a legal remote control
within 1.6m around the vehicle, just pull the
handle of the front door, the door will be
unlocked and opened automatically.
Keyless Locking
Turn off the ignition switch, and flip the sen-
sor zone on the side of the driver or the
handle of the front passenger side door with
your thumb before the door is closed so as
to lock four doors. You do not need to press
the LOCK button on the remote control.
Close the doors, liftgate / truck lid and
engine hood, flip the sensor on the handle
of the front side door or LOCK button on the
remote control to lock the doors (press
LOCK button once), and the turn signals
flash once. The system will enter the pre-
warning state from the anti-theft relief state
(3 seconds) The anti-theft indicator lights
flash rapidly. During this time, if a door, lift-
gate / truck lid or the engine hood is
opened, the system will always stay on
arming state. Otherwise, 3 seconds later,
the system will automatically be transferred
to anti-theft warning state. The anti-theft
indicator lights flash slowly at this moment.
If the doors, liftgate / truck lid or engine
hood is not fully closed, the turn signals will
flash three times, and then the system will
enter an alert state, at the same time, the
anti-theft horn will chime twice every 2 sec-
onds, and the system will enter the anti-
theft arming status 10 seconds later. If you
press the LOCK button within 10 seconds,
the system will stay on the alert status and
then enter the alarm cycle 10 seconds later.
If you press UNLOCK button on the remote
control within 10 seconds, the system will
enter the alarm state from the alert state. In
the alarm state, if you press UNLOCK but-
ton again, the system will stop the alarm
cycle and relieve the anti-theft alarm state.
If you press the LOCK button, the system
will enter the alert state again.
