Geely EC715 2009, Workshop Manual

Page: 1638 / 2181

11.5.2 Description and Operation
11.5.2.1 Description and Operation
Window Regulator Description and Operation
Anti-trap function has the following four kinds of operating
modes: manual-up, manual-down, automatic-up, automatic-
down. Window regulator without anti-trap function has two
kinds of operating modes: manual-up, manual-down. Please
review the configuration instructions before use and confirm
whether the anti-trap function is available.
– Manual - Up
Gently pull the left front door window switch (pull up and the
holding time is less than 500 ms), the left front window rises;
the rest windows operation is the same.
– Manual - Down
Gently press the left front door window switch (press and
the holding time is less than 500 ms), left front window goes
down; the rest windows operation is the same.
– Automatic - Up
Completely pull the left front door window switch (pull up
and the holding time is greater than 500 ms), left front
window rises to the upper limit until the switch is pressed or
pulled up again; the rest windows operation is the same.
– Automatic - Down
Completely press the left front door window switch (press
and the holding time is greater than 500 ms), left front
windows goes down to the lower limit until the switch is
pressed or pulled up again; the rest windows operation is
the same.
Note
During the window rising and doing down period, if
the window switch is pulled or pressed and held for
more than 500 ms, the window will change its moving
direction; If pressing the left front door window switch
no more than 500 ms, the window will stop moving.
– Delay Function
With the ignition switch is turned on, the window is allowed
to move. After 90 s the ignition switch is turned off, the
controller the power will be cut off to disable the operation
of the window.
–
Anti-Trap Function (If Equipped)
The window regulator control module is equipped with an
integrated obstacle detection / anti-trap system.
The anti-trap system works in the window seal all exposed
edges and 4-200 mm within the window seals. Window anti-
trap function requirements: the window has been initialized
in the automatic-up process, any obstacle within 4mm from
the top should activate the anti-trap function and the
window movement should be reversed.
Note
–
If a certain window has not been initialized or has
lost its initialization, there is no automatic-up
function, at this time the anti-trap function will not
be activated.
– The anti-trap function is only available during
window automatic-up process.
The anti-trap system meets the 2000/4/EC specification.
The anti-trap system window anti-trap force shall not
exceed 100 N.
– Comfort Closing Function (If Equipped) (If Equipped With
Anti-Trap Function)
Comfort closing is through a LIN communication to
automatically close the window. Once the comfort closing
instruction is received, all the windows will move upward,
until the windows reach the trip destination (the windows
fully closed position). The activation sequence and delay
requirement is controlled by software. During comfort
closing period, the signal from the window switch will be
ignored, and the anti-trap function is active.
– Motor Protection (If Equipped With Anti-Trap Function)
If the motor runs continuously for longer than 20 s, the
control module shuts down and loses initialization.
– Adaptive Learn (If Equipped With Anti-Trap Function)
The system has the ability to adapt to the vehicle
characteristics and environmental conditions throughout
the vehicle lifetime, such as seals wear.
11-154 Glasses / Windows / Mirrors Body Electric
EC718/EC718RV EC715/EC715RV 10/2009