GEDA Battery Ladder Lift, Assembly And Instruction Manual

Page: 36 / 124

Assembly
Assembly and instruction manual 36 / 124 BL164 GB Edition 07/2017
6.2 Assembly procedure
The installation plan shows the basic assembly stages and their
chronological sequence. However, assembly is in principle based on
the detailed instructions in this manual. If the sequence is changed, the
amended installation plan must be checked by the operating company
to ensure that it is sensible and that there are no potential hazards and
must be subsequently approved.
Assembly procedure
Assembly of the ladder
Lay out the ladder to its full set-up height on the ground
Connect the ladders (only for assembly height > 4.5 metres)
Unwind the webbing from the base unit
Fasten the head section to the upper end of the ladder
Assembly of the BatteryLadderLIFT
Set up the ladder and secure it
Hook the webbing on the head section
Mount the base unit onto the ladder and secure it
Securing the landings
Secure and mark the danger area on the ground.
Inspection after assembly
Check the device before each operation
Instruct personnel authorised on using the device.