32
Installation
The rubber ring supplied is placed over the pipe end.
Make sure that the rubber ring will be placed in the middle
of the sleeve length (h2). Then push the contraction
sleeve over the pipe end. Apply low heat (approximately
125°C) evenly around the socket, moving the blow
lamp constantly. The sleeve will now shrink and give an
absolute watertight and strong connection. Afterwards, fix
the contraction sleeve pipe with an anchor bracket.
For Ø 125 – 315mm use
two soft flames
Geberit
contraction
sleeve
Anchor bracket
Laboratory sink
Pipe end
Ring seal rubber ring
Geberit HDPE
contraction sleeve
Geberit Drainage Systems
Jointing methods
Cast Iron connector
Provides male spigot for direct connection into Ensign
cast iron clamp joint with an internal taper to prevent
damming. HDPE end has spigot for either butt-welding
or electrofusion coupling. Body made from HDPE with
one end enlarged to match Ensign cast iron clamp joint.
Geberit HDPE adapter to cast iron
Article no.
dØ
d1Ø
mm
mm
370.738.16.1
200
212
371.738.16.1
250
274
372.738.16.1
315
326
H
h
d1
d
Cast Iron connector
Made from EPDM it provides male spigot for direct
connection into Ensign cast iron clamp joint with an
internal taper to prevent damming. HDPE end has
spigot for either butt-welding or electrofusion coupling.
Body made from HDPE with one end enlarged to
match Ensign cast iron clamp joint.
Geberit HDPE adapter to cast iron
Article no.
dØ
d1Ø
mm
mm
359.268.16.1
125
135
H
h
d1
d
