Gearlinx™ User Guide v1.0
15
July 24, 2023
1.8.5 NR Console Port
You can connect to the NR4400 via its Console Port. You can use a standard ethernet cable RJ45.
Configure your connection with the following parameters:
•
115200 bits per second
•
8 data bits
•
No parity
•
1 Stop bit
•
No flow control
Like the UI and SSH sections above your username is: Admin and your password is the password
found on the bottom of the NR4400 device.
1.9 Restoring Factory Default
The erase button (on the power face) uses a button pattern to trigger a config erase/reset to factory
default. You will need a paperclip or something small and firm that can fit in the erase hole. To
perform the factory reset you follow these 4 steps in quick succession:
•
Depress the button for a second
•
release it for a second
•
depress it again for a further second
•
release
The unit will then immediately begin its factory reset routine, wiping all cryptographic keys and data
and returning its memory and state to factory default.
