CAUTION: Before you begin
Read these instructions carefully and
completely
• IMPORTANT-Save these instructions for
local inspector’s use.
• IMPORTANT-Observe all governing codes
and ordinances.
GE Self Cleaning Radiant
Electric Drop-In Range
Installation
Instructions
JDP46,JD966
• NOTE TO INSTALLER- Be sure to leave
these instructions with the consumer.
• OWNER- Keep these instructions for future
reference.
• WARNING- This appliance must be
properly grounded. See “Electrical
Requirements” page 2.
Tools You Will Need
Pub. No. 31-10427
229C
4053P413
1
“If you have questions, call 800-GE-CARES
or visit our website at:
www.GEAppliances.com”
Nut driver
Pencil
Hand or
Saber Saw
Straight Edge
or Square
Level
Tape
Measure
Materials Needed
Wire Nuts
Parts Supplied
Safety Glasses
Skill Level:
High
Average
Low
Completion Time:
1 to 3 Hours
Proper installation is the responsibility of the installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty. See the Owners Manual for warranty
information.
1
2
3
4
Phillips
Screwdriver
(Not smaller than #8
gage combined with
house wiring gage.)
(See warning Page
6 if house wiring is
aluminum.)
STD
Screw
Driver
Junction Box
(If not included in
house wiring)
4- 11/16” x 4- 11/16” x 2- 1/4” Sq.
Min. (See N.E.C. for space require-
ments)
Hammer
Lower Trim
2 Screws
Power Drill
& 1/8” Bit
2 Shoulder
screws (for stop
device)
Summary of Contents for JDP46
Page 15: ...15 NOTES...
