GeaCom Phrazer Kitsune, User Manual

Page: 20 / 69

G E T T I N G S T A R T E D W I T H P H R A Z E R / K I T S U N E
3.2 Pairing and Connecting Kitsune - Patient
"
Note Connecting Kitsune is a two-step process. The Kitsune first needs to pair with the device then
connect to an audio stream. Phrazer performs both processes when an audio source is selected
and Kitsune is in pairing mode.
" Note If using a Kitsune already connected with Phrazer, never unpaired, Phrazer will automatically
remember the Kitsune when powered on. Verify the connection by listening to test audio in
Bluetooth settings. In some cases, disconnecting and reconnecting Kitsune is required.
"
Note Pop-ups are used in Bluetooth settings to indicate when a Kitsune had been connected or
disconnected from an audio source.
To pair and connect new Kitsune:
1. Get Kitsune into pairing mode:
a. On Kitsune, slowly swipe the Crypto Key once across the LED on the right ear cup to turn
ON, you should see a solid blue light followed by a flashing blue light.
b. From the flashing blue light, slowly swipe the Crypto Key across the LED again. LED
should flash between red and blue. Kitsune is now in pairing mode lasting for 10 seconds. If
Kitsune reverts back to the flashing only blue, another swipe with the Crypto Key will get
Kitsune back into pairing mode again for 10 seconds.
2. While in pairing mode slide the back band of Kitsune across the right side of Phrazer to activate the
connectivity tag. When activated, the LED on Kitsune will turn purple and you will be prompted on
Phrazer to select an audio stream.
!
To connect a Patient Kitsune that has been previously connected:
1. Turn Phrazer on by swiping the Crypto Key over the ON/OFF switch (see chapter 3.1).
2. On Kitsune, slowly swipe the Crypto Key once across the LED on the right ear cup to turn ON, you
should see a blue light followed by a solid purple light.
3. The purple light will turn blue once the connection is established.
! 15