Instructions for use and maintenance
This manual is owned by GEA Niro Soavi Any reproduction, even partial, is prohibited.
03C100-4C0
GEA Niro Soavi
47
3.3 Work area, control area, danger zones
In order to facilitate comprehension of the matters handled in this paragraph, the following definitions
of Machinery Directive 98/37/EEC apply:
- “Work areas”
areas in which the operators may stay during startup and normal operation.
These areas also enable them to take prompt action in case of need or emergency, within the
limits of their job descriptions and established procedures.
The work areas are located around the system in the areas to which access is permitted during
operation.
- “Control areas”
areas in which operators may control, monitor and adjust the system, using the provided control
panels.
- “Danger zones”
any zone inside or in the vicinity of the machine, in which the presence of an exposed person
constitutes a hazard for the health and safety of the person in question.
The danger zones are located around the system.
- “Exposed person”
any person entirely or partly in a danger zone.
- “Operator”
a person charged with installing, operating, adjusting or servicing, cleaning, repairing and handling
the system.
CAUTION:
The machine may be operated and monitored in normal working conditions only from the
designated control area.
The
control, work and danger areas are shown in the figure on the next page.
Summary of Contents for Niro Soavi One7TS
Page 2: ......
