Installation
Installing the pump
2007-9015-001
03-2014
5.5
Installing the pump
Warning!
Always shut off and lock the power supply before installing the
equipment.
Caution!
Never allow bystanders to stay close to the pump when it is lifted.
Caution!
Sharp edges may cause cuts.
To install concrete anchor bolts properly, refer to the Technical Data
Section on Concrete Anchor Bolt.
To tighten bolts adequately, refer to the Technical Data Section on Bolt
Torque Chart.
5.5.1
Positioning the pump
● Lift the pump and position it in the pit according to the minimum dimensions
for the particular installation configuration.
Refer to section on Minimum pit dimensions for installing the pump
in a service pit.
● Anchor the pump to the fit floor with
4 anchor bolts (1/2” x 3¾” [13 x
95mm] stainless steel bolts). Refer
to section on Concrete anchor bolts
specifications.
Anchor bolts
