(continued)
Oven Light Replacement
some models )
CAUTION: Before replacing your oven light bulb,
DO NOT REMOVE ANY SCREWS TO
disconnect the electrical power to the range at the
REMOVE COVER.
main fuse or circuit breaker panel. Be sure to let
2. Do not touch hot bulb with a wet cloth. Replace
the light cover and bulb cool completely.
bulb with a 40-watt household appliance bulb.
The oven light bulb is covered with a removable
To replace cover:
glass cover
that is held in place with a bail-shaped
wire. Remove the oven door, if desired, to reach
1. Place it into the groove of the light receptacle. Pull
cover easily.
the wire forward to the center of the cover until it
To remove:
1. Hold a hand under the
cover so it doesn’t fall
when
With
fingers of the same
hand,
push back
the wire cover holder.
Lift off the cover.
snaps into place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
2. Connect electrical power to the range.
Wire
holder
Control Panel and Knobs
It’s a good idea to wipe the control panel after each
use of the oven. Clean with mild soap and water or
vinegar and water, rinse with clean water and polish
dry with soft cloth.
Do
use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the control
panel—they will damage the finish. A 50/50 solution
of vinegar
hot water works well.
The control knobs may be
—
removed for easier cleaning.
To remove a knob, pull it
straight off the stem. If knob
is difficult to remove, place
a towel or dishcloth between
the knob and control panel and pull gently. Wash the
knobs in soap and water or a vinegar and hot water
solution but do not soak.
parts can be cleaned with soap and water.
Do not use steel wool, abrasives, ammonia, acids or
commercial oven cleaners. Dry with a soft cloth.
Removable Storage Drawer
(on some models)
The storage drawer is a good place to store cookware
To remove storage drawer:
and
Do not store plastics and flammable
1. Pull drawer straight
material in the drawer.
out until it stops.
Do
overload the storage drawer. If the drawer
2. Tilt the front of the
is too heavy, it may slip
the track when opened.
up and free of the range.
The storage drawer may be removed for cleaning
To replace storage drawer:
under the range. Clean the storage drawer with a
damp cloth or sponge. Never use harsh abrasives
1. Set the stops on the back of the drawer over the
or scouring pads.
stops in the range.
2. Slide drawer evenly and straight back, so that the
rails in the range are engaged.
28
