H
OW
to Use the Soak
models equipped)
●
Turn the Cycle Selector knob to soak. Start
●
NOTE: For an extended soak, allow the washer
the washer. Add pre-measured detergent or soak
to fill
agitate
a few minutes to dissolve the
product; add clothes.
soaking agent. Then push in the Cycle Selector knob
to stop the washer (keep lid closed) and allow to
soak for as long as desired. After desired soak
period,
out the Cycle Selector knob to complete
the cycle.
H
OW
to Use the Auto Soak Cycle
(on
so equipped)
In the Auto Soak cycle the washer fills, agitates and
●
PreWash with Auto Soak: Set the Cycle Selector
it soaks for the time you selected. It automatically
knob for soak time desired in the PreWash cycle.
advances into the next
Start the washer. The washer will agitate, soak and
automatically advance into PreWash.
●
Extra Cleaning with Auto Soak: Set the
Cycle Selector knob for soak time desired in
Extra Cleaning cycle. Start the washer. The washer
will agitate, soak and automatically advance into
Extra Cleaning.
H
OW
to Use the Quick Wash Cycle
(on models so equipped)
The QUICK WASH cycle is a short cycle, intended
1. Push the Cycle Selector knob in and turn it
to wash small loads of lightly soiled clothes you
clockwise to the QUICK WASH cycle.
need in a hurry.
2. Pull the Cycle Selector knob out to start the washer.
ENERGY-SAVING
If your clothes and household items don’t look clean
●
Always rinse in cold water. The temperature
and fresh after washing, you will probably rewash
of the rinse does not affect cleaning.
them.. and that means
waste energy.
Remember to sort your clothes carefully, and load
●
Wash in off-peak utility hours. Your local utility
them properly, select correct cycles, use enough
can tell you which are the off-peak hours.
detergent and
water temperature warm
●
Use your washer’s Normal Spin. This will remove
release and
rid
more water during spin, which will shorten drying
.
to wash less often. Save articles of the same
cycle to save more energy.
type of fabric until you have a
load.
●
If you must wash smaller loads, adjust the amount
of water. Small loads should have
water levels.
11
