Starting the System
4.3 Turn
on
Power
1. Connect the Power Cable to the back of the system.
2. Connect the Main Power Cable to a hospital grade power receptacle with the proper rated voltage.
WARNING:
Never use an adapter that would defeat the safety ground.
3. Switch ON the Circuit Breaker and the Power Switch of Peripherals at the rear of the system.
Note:
The switch of the monitor has to be in ON position before starting the system.
Leave monitor power switch always ON.
4. Push the ON/OFF Standby switch left below the control panel once.
For its location review:
System Configuration
.
Once system is switched on, it is completely reset. The boot-up time is about 2 minutes, and then the
2D mode main menu for the previously selected transducer is displayed.
In case, however, it was disconnected, the menu "PROBE/PROGRAM" will appear.
Remarks:
•
The mains outlets of the system for peripheral auxiliary equipment are commonly switched
with the Standby switch. The switch of printers has to be in ON position before starting the
system. However, be aware some auxiliary equipment may switch itself to standby mode when
Standby power is on (e.g., Color video printer) and must therefore be switched on separately.
The auxiliary equipment need not be switched ON/OFF separately if the
F2
power switch on the
back of the system and the switches of the peripherals are always ON.
•
The system’s monitor has its own main switch, which is normally always left ON.
If found off, resp. if here is no information on the screen, switch it on.
Voluson
®
730 - Instruction Manual
105838 Rev. 3
4-3
