GE UTX878 Ultrasonic, User Manual

Page: 38 / 103

March 2004
2-14 Programming Site Data
Entering Reynolds
Correction Data (cont.)
3. The menu varies, depending on your selection in Step 2.
•
If you select Off , no further choices are available.
•
If you select Single , the UTX878 will select and automatically
display the Kinematic Viscosity . To change the value, press [ENT].
Use the arrow keys to change the value (available in document
#914-004,
Sound Speeds and Pipe Size Data ), and press [ENT].
•
If you select Table , the screen displays three options: Units, Rows
Used and Edit Table.
a. If you scroll to Units and press [ENT], the screen displays three
more options: Velocity, Soundspeed and Diagnostic . If you
select either Velocity or Soundspeed and press [ENT], the
screen displays the measurement units (either metric or
English). Press [ESC] or [ENT] to return to the previous
screen. But if you scroll to
Diagnostic and press [ENT], the
meter asks for the type of signal to be used, Signal Strength Up
or Signal Strength Dn . Scroll to the appropriate signal, and
press [ENT].
b. If you select Rows Used , the program asks for the number of
rows you wish to use. Enter the desired number (from 2 to 20)
and press [ENT].
c. If you select Edit Table , the table opens with a series of rows .
Scroll to the desired row, and press [ENT].
d. For each row, the screen displays the Reynolds Correction
number (X) and the Kinematic Viscosity (KV). If you wish to
change either value, scroll to the value and press [ENT]. Use
the arrow keys to change the value (available in document
#914-004,
Sound Speeds and Pipe Size Data ), and press
[ENT].
e. Repeat steps c and d until you have programmed all of your
available data (from 2 to 20 rows).
Press [ESC] until you return to the PROG menu, or continue pressing
[ESC] until the display screen reappears.