GE UR series, Instruction Manual

Page: 153 / 652

GE Multilin L60 Line Phase Comparison System 5-21
5 SETTINGS 5.2 PRODUCT SETUP
5
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first “Off” value. Since DNP /
IEC 60870-5-104 point lists must be in one continuous block, any points assigned after the first “Off” point
are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the L60 is restarted.
g) IEC 61850 PROTOCOL
PATH: SETTINGS
Ö
PRODUCT SETUP
ÖØ
COMMUNICATIONS
ÖØ
IEC 61850 PROTOCOL
The L60 Line Phase Comparison System is provided with optional IEC 61850 communications capability.
This feature is specified as a software option at the time of ordering. Refer to the
Ordering section of chap-
ter 2 for additional details. The IEC 61850 protocol features are not available if CPU type E is ordered.
The L60 supports the Manufacturing Message Specification (MMS) protocol as specified by IEC 61850. MMS is supported
over two protocol stacks: TCP/IP over ethernet and TP4/CLNP (OSI) over ethernet. The L60 operates as an IEC 61850
server. The
Remote inputs and outputs section in this chapter describe the peer-to-peer GSSE/GOOSE message scheme.
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.
PATH: SETTINGS
Ö
PRODUCT SETUP
ÖØ
COMMUNICATIONS
ÖØ
IEC 61850 PROTOCOL
Ö
GSSE/GOOSE CONFIGURATION
The main transmission menu is shown below:
„
IEC 61850 PROTOCOL
„
„
GSSE / GOOSE
„
CONFIGURATION
MESSAGE
„
SERVER
„
CONFIGURATION
MESSAGE
„
IEC 61850 LOGICAL
„
NODE NAME PREFIXES
MESSAGE
„
MMXU DEADBANDS
„
MESSAGE
„
GGIO1 STATUS
„
CONFIGURATION
MESSAGE
„
GGIO2 CONTROL
„
CONFIGURATION
MESSAGE
„
GGIO4 ANALOG
„
CONFIGURATION
MESSAGE
„
REPORT CONTROL
„
CONFIGURATION
MESSAGE
„
XCBR
„
CONFIGURATION
MESSAGE
„
XSWI
„
CONFIGURATION
„
GSSE / GOOSE
„
CONFIGURATION
„
TRANSMISSION
„
MESSAGE
„
RECEPTION
„
NOTE
NOTE