GE UR Series L90, Instruction Manual

Page: 434 / 846

5-296 L90 Line Current Differential System GE Multilin
5.7 CONTROL ELEMENTS 5 SETTINGS
5
(EQ 5.38)
In the above equations,
• Δ t is the power cycle duration.
• n is the power cycle index.
• t
op ( In )
is the trip time calculated at index n as per the IEC255-8 cold curve or hot curve equations.
• t
rst ( In )
is the reset time calculated at index n as per the reset time equation.
• I
n
is the measured overload RMS current at index n .
• E
n
is the accumulated energy at index n .
• E
n – 1
is the accumulated energy at index n – 1.
The thermal overload protection element removes the
THERMAL PROT 1 OP
output operand when E < 0.05. In case of
emergency, the thermal memory and
THERMAL PROT 1 OP
output operand can be reset using
THERM PROT 1 RESET
setting.
All calculations are performed per phase. If the accumulated energy reaches value 1 in any phase, the thermal overload
protection element operates and only resets when energy is less than 0.05 in all three phases.
The logic for the thermal overload protection element is shown below.
Figure 5–160: THERMAL OVERLOAD PROTECTION SCHEME LOGIC
Table 5–29: TYPICAL TIME CONSTANTS
PROTECTED EQUIPMENT TIME CONSTANT MINIMUM RESET TIME
Capacitor bank 10 minutes 30 minutes
Overhead line 10 minutes 20 minutes
Air-core reactor 40 minutes 30 minutes
Busbar 60 minutes 20 minutes
Underground cable 20 to 60 minutes 60 minutes
E
n
E
n 1
–
t

t
rst In
 
---------------
– =
6(77,1*6
(QDEOHG
)XQFWLRQ
2II
%ORFN
$1'
6(77,1*
,$506
6RXUFH
,%506
,&506
6(77,1*6
,$!Nî,E
.)DFWRU
,%!Nî,E
,&!Nî,F
%DVH&XUUHQW
25
$1'
6(77,1*
7ULS7LPH&RQVWDQW
581
(!
6(77,1*6
5HVHW7LPH&RQVWDQW
581
(
0LQLPXP5HVHW7LPH
5HVHW(WR
6(77,1*
2II
5HVHW
/DWFK
6
5
5HVHWGRPLQDQW
)/(;/2*,&23(5$1'
7+(50$/352723
)/(;/2*,&23(5$1'
7+(50$/35273.3
$&'5