Figure 3: TruVision dimensions - camera orientation
Maintenance
To clean inside and outside the camera, do not use any organic or
corrosive cleaning solutions. When cleaning the camera, turn off
the power, and use a clean cloth with some water.
Specifications
Pickup device
1/3 in. interline transfer CCD
Total pixels
NTSC: 811 (H) x 508 (V)
PAL: 795 (H) x 596 (V)
Effective pixels
NTSC: 768 (H) x 494 (V)
PAL: 752 (H) x 582 (V)
Resolution
500 TV lines
Synchronization system
Internal synchronization
Scanning system
NTSC: 525 lines / 60 fields
PAL: 625 lines / 50 fields
S/N ratio
>48 dB
Electronic shutter
Auto 1/60 (1/50)
Minimum illumination
0.2 lux at F2.0
Video output
1.0 Vp-p, 75
Ω
White balance
Automatic
Lens type
Board lens / DC varifocal lens
DC power source
12 VDC, 500 mA /24 VAC,185 mA
Power consumption
<2.2 W max.
Operating temperature
−
10 to 50°C (14 to 122°F)
FCC information
Cautions
This device complies with Part 15 FCC Rules. Operation is subject
to the following two conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received including
interference that may cause undesired operation.
Compliance
This Equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the service technician is encouraged to
try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
Manufacturer
GE Security, Inc., 8985 Town Center Parkway,
Bradenton, FL 34202, USA
Year of
manufacture
The first two digits of the product serial number
(located on the product identification label) are the
year of manufacture.
Certification
North American
standards
FCC Part 15, Subpart J, Class B
European Union
directives
2002/96/EC (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For
more information see: www.recyclethis.info.
2004/108/EC (EMC directive): Non-European
manufacturers must designate an authorized
representative in the Community. Our authorized
manufacturing representative is:
GE Security B.V., Kelvinstraat 7,
6003 DH Weert, The Netherlands.
Contact information
For contact information see our Web site: www.gesecurity.com.
2 of 2
P/N 1069136 • REV 1.0 • ISS 27OCT09
