GE TMO2D, User Manual

Page: 63 / 102

TMO2D Digital Display User’s Manual 55
Chapter 5. Advanced Programming
Chapter 5. Advanced Programming
5.1 Introduction
In addition to its basic program, the TMO2D analyzer contains a factory setup program that enables the user to perform
more advanced operations on the parameters that have been first installed at the factory. This program has eight main
menus. Use the front panel keypad and display to check or change the settings for current operating parameters. New
data overrides any previously entered data.
IMPORTANT:
Consult GE before changing any parameters in this menu.
The user program consists of eight main menus:
•
Set Significant Digits
•
Select Background
•
Select Tracking
•
Select Tertiary
•
Response Parameters
•
Labcal Outputs
•
Manual Offset
•
Change AutoCal Limits
5.2 Entering Data into the Factory Setup Program
To enter data into the program or to check previously entered values, enter the Factory Setup Menu Mode. When you
turn the power on, the TMO2D enters the Operate Mode. To enter the Factory Setup Menu Mode:
1. Press the [NO] key.
2. Key in the code [3] [6] [9]. The TMO2D will display an asterisk (*) after you enter each digit.
If you enter an incorrect code or press a non-numeric ([YES]/[NO] or arrow) key rather than 3 6 9, the LCD will
automatically resume displaying data, and you must press [NO] to re-attempt the code. Once all three digits have been
entered correctly, the display will cease collecting data and the LCD will switch to the Factory Setup Menu Mode.
The LCD screen now displays the Set Significant Digits? menu, the first of the eight main menus. At this display, press
[YES] to enter this menu, or [NO] to scroll to the next menu. Pressing [NO] continuously scrolls through all eight main
menus. Refer to Figure 30 on page 83 for a flow diagram of the Factory Setup Menu.
Note:
The first eight options are main menus, while the “RESUME” prompt enables you to exit the Factory Setup
Menu Mode and return to Operate Mode.