GE RSDetection RS-S131-200-ER0000, User Manual

Page: 58 / 94

RSDetection
User’s Manual
March 2016 S131-200-UM Rev A
Page 44
g
5.3.3.6 Serial Port Configuration Parameters
The number of serial ports available for configuration (if any) is determined by the number
of USB to serial port adapters connected. A serial port requiring configuration is enabled
within the RSDetector unit for each device connected.
Table 13 Serial Ports Configuration Parameters
Parameter Variable Property Description Choices
SerialPort BaudRate Determines the BAUD rate of the
serial port. A drop down list
determines the
choices.
NumberOfBits The number of bits used in the
transmission of a character. 7 or 8
Parity Parity of the transmitted byte. A drop down list
determines the
choices or Even,
Odd or None.
5.3.3.7 RSDetection Configuration Parameters
This selection covers a number of properties that govern the overall system operation.
Table 14 RSDetection Configuration
Parameter Variable Property Description Choices
Control BiasVoltageOnAt
Startup If true, the high voltage bias
(nominally 400V) will be applied at
startup. True
False
LoggingEnable A global enable that when false will
disable all logging and if true logging
will be determined by the
measurement or event configuration. True
False
NotifyEnable A global enable that when false will
disable all notifications and if true
logging will be determined by the
measurement or event configuration. True
False
Legacy DateFormat The older units allowed for 3 types of
date output. This corresponds to the
legacy DTF command. MM_DD_YY
DD_MM_YY
YY_MM_DD
UnitAddress The legacy commands used a single
character address for selecting which
unit was being addressed. This
corresponds to the UID legacy
command. Single character
from ‘0’ to ‘Z’
excluding ‘@’