GE RPV311, Technical Manual

Page: 283 / 295

RPV311 Appendix A
– Equipment Log
Chapter 18
– Wiring Diagrams
RPV311-TM-EN-7 283
RPV311
Distributed Multifunction Fault Recorder
Appendix A
1 Equipment Log
The equipment log contains information about:

Threshold violations, fault and disturbance triggers and data recording;

Data record transfer (including the IP address to which data has been
transferred);

Access to the unit's configuration pages (including IP address of which the
access was performed);

Alarms and the results of auto-diagnosis routines;

Power-up and shutdown.
The equipment log cannot be erased by the user. Its capacity is enough for
approximately 5 years of typical use, with past events being erased if memory space
is needed.
Log Event Cause
000 Internal failure Hardware or processing failure
001 Invalid key The key applied to the
equipment is not valid
010 Power up Equipment power-up
011 Power off Equipment power-off
012
Auto power-off (primary
power failure) Battery operated power time
run-out
013 Emergency power-off
(low battery) Battery charge below expected,
equipment shut off
automatically
020 Primary power OK Primary power supply voltage
equipment
021 Primary power NOK Battery backup equipment