0020507767ZB
31-3000212 Rev. 0 07-19 GEA
INSTALLATION
INSTRUCTIONS
RISER KIT
For Washer Models: GFW148, QFT150
For Vented Dryer Models: GFD14, QFD15
For Condenser Dryer Models: GFT14, QFT15
For Combi Washer/Dryer: GFQ14
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
–
Save these instructions for
local electrical inspector’s use.
•
IMPORTANT
–
Observe all governing
codes and ordinances.
•
Note to Installer
–
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer
–
Keep these instructions for
future reference.
• Service
must
be performed by a qualified installer.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of the installer.
• Completion time - 30-60 minutes
WASHER REQUIREMENTS
FOR ALCOVE OR CLOSET
INSTALLATION
• Minimum clearance between washer cabinet and
adjacent walls or other surfaces is:
0” either side
1” front and rear
1” top
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches
(387.1 square centimeters of open area. If the
closet contains both a washer and a dryer, doors
must contain a minimum of 120 square inches
(774.2 square centimeters) of open area.
DRYER REQUIREMENTS FOR
ALCOVE OR CLOSET INSTALLATION
• Minimum clearance between washer cabinet and
adjacent walls or other surfaces is:
0” either side
1” front and rear
1” top
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches
(387.1 square centimeters of open area. If the closet
contains both a washer and a dryer, doors must
contain a minimum of 120 square inches (774.2
square centimeters) of open area.
Keep flammable materials and vapors, such as gasoline,
away from dryer.
Place dryer at least 18” (46 cm) above the floor for a
garage installation.
Failure to do so can result in death, explosion, or fire.
- Explosion Hazard
WARNING
MINIMUM CLEARANCE OTHER
THAN ALCOVE OR CLOSET
INSTALLATION
Minimum clearance to combustible surfaces and for air
opening are: 0” both sides, 1” rear and 1” top.
Consideration must be given to provide adequate
clearance for installation and service.
TOOLS YOU WILL NEED
ʄ
Safety glasses
ʄ
Gloves
ʄ
9/16" Open End Wrench
or Adjustable Wrench
ʄ
5/8" Deepwell Socket
Wrench or 5/8" Socket
Wrench with Extension
ʄ
Phillips screwdriver
If you have any questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Website at:
GEAppliances.com
In Canada, call 800.561.3344 or visit GEAppliances.ca
