GE QuickPanel+, User Manual

Page: 53 / 62

Appendix A Product Certifications and
Installation Guidelines
The QuickPanel + Operator Interface is intended for use in industrial environments and,
when properly installed, shall comply with the agency approvals listed in this chapter.
Agency Approvals
Note
The agency approvals listed in the following table and on the Declaration of
Conformities are believed to be accurate; however, the product’s agency approvals should
be verified by the marking on the unit itself.
Description Agency Marking Comments
N.A. Safety for Programmable
Controller for use in Hazardous
locations
Class I Division 2 Groups A,B,C,D
Certification by Underwriter's Laboratories to UL 61010-1;
UL61010-2-201;
CSA C22.2 No 142 – M1987; CSA 61010-1; CSA 61010-2-201
ISA 12.12.01 standard and CSA C22.2 No 213-M1987
Electromagnetic Compatibility
Directive
European Electromagnetic
Compatibility (EMC) for Industrial
Control Equipment
Self-declaration in accordance with European Directives
EN61000-6-2, EN61000-6-4
Conditions of Safe Use for Installation in Hazardous Locations
The following information applies to products bearing the UL marking for Hazardous
areas for explosive atmospheres:
Suitable for use in Class I Division 2 Groups A, B, C, D.
Warning
EXPLOSION HAZARD — Class I Division 2 Groups
A, B, C, D; do not disconnect equipment unless power
has been removed or the area is known to be
non-hazardous.
EXPLOSION HAZARD — Substitution of components
may impair suitability.
EXPLOSION HAZARD — DO NOT VESA MOUNT.
Panel mount only with enclosures that shall only be able
to be opened with the use of a tool.
Appendix A Product Certifications and Installation Guidelines GFK-2847F User Manual 53
For public disclosure