GE QuickPanel Plus IC755CxS06RDx, User Manual

Page: 69 / 112

5.6 Battery Installation and Replacement
Warning
Batteries may present a risk of fire, explosion, or
chemical burn if mistreated. Do not crush,
disassemble, short-circuit, or dispose of in fire.
Use of batteries not specified for use with the
QuickPanel
+ product may present a risk of fire or
explosion.
Warning
Do not recharge, disassemble, heat or incinerate
lithium batteries.
Dispose of lithium batteries in accordance with
federal, state, and local regulations. Be sure to
consult with the appropriate regulatory agencies
before disposing of batteries.
Caution
1) Replacing the battery should only be performed
by trained personnel and in a non-hazardous
location.
2) If the QuickPanel + Operator Interface is VESA
mounted, detach from the VESA arm when
replacing the battery.
3) The battery should only be replaced when the
unit is powered off.
4) Care should be taken to protect and insert the
battery with correct polarity.
5) Do not use any metallic item to remove the
battery (such as screwdrivers, knives, pliers, and so
forth).
6) Be careful to not drop the battery or any
associated screws into the unit.
7) Be careful of edges on internal sides of the
enclosure and frame.
Attention
The PC controller does not start automatically when
the battery is replaced in QuickPanel
+ Operator
Interface. After battery replacement, start the
controller using the #Command in the Proficy
Machine Edition (PME) runtime.
Mounting and Installation GFK-2847Q 69
For public disclosure