GE QuickPanel Plus IC755CxS06RDx, User Manual

Page: 66 / 112

5.4 Mounting and Installation Procedure
Observe the following guidelines to properly mount and install the QuickPanel + Operator
Interface:
To order replacement gaskets,
refer to the part number listed
in
Appendix B .
• The enclosure should be of metal material.
• The metal enclosure panel should ensure proper thickness and rigidity suitable to
minimize impact to the QuickPanel
+ unit.
• The recommended torque for the plastic back cover and interior metal cover for the
10, 12, and 15” QuickPanel
+ display units that is accessed for panel updates and
serial port DIP Switches is 0.5 Nm (4.4 in-lb).
• To avoid gasket degradation, limit repeated insertions or removals of the unit and
retightening of the mounting clips. For full protection, always use a fresh gasket.
• The unit will not fit through the cutout with any cables connected, or with the power
supply plug inserted in the socket.
Caution
When installing the QuickPanel
+
into the panel, pay
careful attention while handling the unit so it does
not drop and damage the unit.
➢ ➢ To install the QuickPanel +
1.
Cut an opening in the panel according to the specifications in the following figures.
Note
Panel cutout tolerances are +0.50, –0.00 mm (+0.02, –0.00 in).
Panel Thickness:
1.0 to 5.0 mm
(0.04 to 0.20 in)
1
2
8
.5
0
m
m
(
5
.0
6
i
n
)
183.50 mm (7.22 in)
IC755CxSO6RDx or IC755CxW07CDx
Panel Cutout Dimensions
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
266 mm (10.47 in)
2
1
0
m
m
(
8
.2
7
i
n
)
IC755CxS10CDx Panel Cutout Dimensions
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
2
2
8
m
m
(
8
.9
8
i
n
)
302 mm (11.89 in)
IC755CxS12CDx Panel Cutout Dimensions
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
379 mm (14.92 in)
3
0
5
m
m
(
1
2
.0
1
i
n
)
IC755CxS15CDx Panel Cutout Dimensions
66 GFK-2847Q QuickPanel ⁺ Operator Interface User Manual
For public disclosure