`
show node
GFK-2572
Chapter 2 Monitor Level Commands
2-43
2
show node
Global Command
This command displays device identification and physical module information.
Show node
is
equivalent to the
node
command.
The
show node
command shows
id
and
info
data.
all
parameter – displays id, info
and
status data.
id
parameter - displays PROFINET Device name, IP Address, subnet mask and default
gateway.
info
parameter - displays Type of Device, Device Catalog number, Copyright notice, Primary
firmware revision, Boot firmware revision, BOC revision (where applicable), FPGA revision and
PROFINET IO communications stack version
status
parameter - restart reason code (Power cycle, reset pushbutton, fatal error), and other
module status. In addition,
status
shows whether the configuration data source of all
configuration is from the Programmer or if any configuration parameters have been set via
another means (Command Line Interface, DCP or default values) (See
Config Source
in the
example below. The valid values are
Programmer
or
Other
).
show node Command Format
show node [all | id | info | status]
