GE NetworX Series, Manual

Page: 7 / 17

Or to change the armed status to INSTANT, press
ρ 3
again.
Step 4 “SYSTEM IS ARMED IN STAY MODE. ENTER CODE
TO DISARM. EXIT DOOR DELAY IS OFF.” Your
system is now armed in the INSTANT mode with no exit
delay.
Step 5 To toggle from the INSTANT mode to the STAY mode and
vice versa, simply press
ρ 3
.
Step 6
To exit, press the
#
key.
Section V. D
ISARMING
Y
OUR
S
ECURITY
S
YSTEM
When the “Operator” is on the line to a system is in the ARMED state,
the System Status will be stated as "SYSTEM IS ARMED, ENTER
CODE TO DISARM". To DISARM your system at this point, enter an
authorized 4-digit user code and the “Operator” will say "SYSTEM
READY, ENTER CODE TO ARM". Your security system is now
DISARMED. You may hang up or go to another MENU option.
Section VI. B
YPASSING
Z
ONES
Your security system must be DISARMED to perform the bypass
procedure. When you disarm your system, all bypassed zones will
automatically unbypass. Since your system’s arming procedure ignores
bypassed zones, these instructions should only be given to authorized
persons.
When the “Operator” is on the line, perform the following steps to
bypass or unbypass any of the zones in your security system.
Step 1
Press
ρ 9 0
.
The [ ρ ] accesses the main MENU, [9] gives the OPTIONS
menu, and [0] provides the ZONE LIST.
Step 2 The “Operator” will state the condition of each individual
zone with one of the following messages:
“ZONE 1 IS SECURE. TO BYPASS ENTER [0] NOW.”
“ZONE 2 IS BYPASSED.”