GE MP100 Series, Service Manual

Page: 128 / 314

6-34 CIC Pro™ 2026419-033E
Configuration
9. When all of the connected touchscreen displays are calibrated, click OK from the
Elo Touchscreen Properties window.
Touchscreen calibration using the Touchware application
If a single display is connected to the CIC Pro center
1. If you have a secondary display connected to the CIC Pro center, you must
disconnect it before calibrating the primary display.
2. Log on to the CIC Pro center as Administrator on page 4-3 .
3. From the Windows desktop, double-click the Calibration icon.
4. Follow the onscreen instructions to touch each of the targets displayed.
5. Click Accept .
6. Click OK .
7. Perform safe shutdown of the CIC Pro center on page 8-31 .
8. Connect the secondary display to the CIC Pro center.
9. Power on the CIC Pro center.
10. Proceed to Configure a secondary display on page 6-30 .
Set the time zone
NOTE
To change the time zone, daylight saving time, time-of-day, or the date on a CIC
Pro center on a v4.0.x or v4.1.1 software or later, see the CIC Pro Clinical
Information Center Service Manual that was provided with your equipment.
NOTE
Do not set the time zone until all other configuration steps have been completed.
Setting the time zone
must be the last step before configuring the clinical settings.
1. Disconnect the CIC Pro center from the CARESCAPE Network IX and MC
networks.
2. Log on to the CIC Pro center as Administrator on page 4-3 .
3. From the Windows system tray, double-click the (time) icon.
4. On the Date and Time Properties window, click the Time Zone tab.
5. Select the time zone from the drop-down list next to the time zone setting.
NOTE
Sri Jayawardenapura time is listed as GMT + 5:30 for CIC Pro center
software v5.1.x and GMT + 6.00 for CIC Pro center software v.5.0.x and
earlier.