Installation
Dual Burner Outdoor Cooktop
• All built-in installations should be at least
35-1/2" above the floor.
Clearances to Combustibles:
• Allow at least 6" clearance from the back and
sides to any combustible material.
• Allow at least 1" clearance below the cooking
surface on all sides.
Installation in a combustible enclosure:
• Installation into a combustible enclosure
requires the ZX2JYSS insulated jacket.
• The insulated jacket must be supported from
the bottom by a solid deck or ledge on each
side beneath the jacket.
6
2
A
Installation
Into An
Enclosure
(Skip this step
if burner is installed
on a grill cart)
Step
Installation in a non-combustible enclosure:
• In a non-combustible (masonry) enclosure,
the burner drops into the opening. A solid
deck beneath is required for support from
the bottom.
Combustible enclosure with Insulated Jacket
Non-combustible enclosure
To install trim kit ZX2TKYSS:
• Remove the cover and burner grate.
• Place side trim and rear trim pieces over the
burner edges, overlapping the countertop
surface.
• Install screws from the inside of the burner
and through the trim. 3 each on all sides.
NOTE: The trim kit is not designed to support
the weight of the Dual Range Top Burner.
Support from the bottom must be provided.
24-5/8"
11"
2x2
Opening
for Gas
Supply
Line
1-1/8"
1"
15-3/8"
23-5/8"
10-3/8"
13-1/8"
2x2
Opening
for Gas
Supply
Line
