GE MDS ORBIT ECR, Technical Manual

Page: 205 / 463

MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 205
Figure 3-110. Bridging Functions Diagram
Configuring
Creating a bridge interface and assigning it an IP address:
% set interfaces interface Bridge type bridge
% set interfaces interface Bridge bridge-settings ageing-time 500
% set interfaces interface Bridge ipv4 address 192.168.1.10 prefix-length 24
Adding LAN (ETH1) interface to the bridge:
% set interfaces interface Bridge bridge-settings members port ETH1
Adding WiFi interface (in Access Point mode) to the bridge:
% set interfaces interface Bridge bridge-settings members wifi-ap myssid
OR:
Adding WiFi interface (in Station mode) to the bridge:
% set interfaces interface Bridge bridge-settings members wifi-station
interface Wi-Fi
Removing LAN (ETH1) interface from the bridge:
% delete interfaces interface Bridge bridge-settings members port ETH1
Removing WiFi interface (in Access Point mode) from the bridge:
% delete interfaces interface Bridge bridge-settings members wifi-ap somessid
OR:
Removing WiFi interface (in Station mode) from the bridge:
% delete interfaces interface Bridge bridge-settings members wifi-station interface Wi-Fi
Removing the bridge interface:
% delete interfaces interface Bridge
Monitoring
Ensure the CLI is in operational mode. Follow the example below to view the state and statistics of a
bridge. In this example, bridge (Bridge) is bridging the LAN (ETH1).
> show interfaces-state interface Bridge
interfaces-state interface Bridge