![background image](http://html.mh-extra.com/html/ge/lullaby-warmer/lullaby-warmer_maintenance-and-service-manual_128643121.webp)
Lullaby
TM
Warmer 2042376-001 Rev G ©2012 General Electric Company. All rights reserved. 95
Description
Instructions to replace the cable harness:
Follow the instructions given below to replace the cable harness:
1.
Remove the pillar rear cover.
2.
To replace the switch cable assemblies, disengage connectors and push the switch along
with cable outside the control panel cutout.
3.
Replace the old cable with a new one.
4.
Guide the cable from the front side of the control panel cut-out.
5.
Secure the connectors.
6.
To replace the cables of the power inlet refer to 7.1.20 Replacing the Plate Power Inlet.
7.
Refer to Replacing the Heater Assembly and Cables for replacing heater cables,
observation lamp cables and the swivel sensor cable.
Instructions to replace the transformer
Follow the instructions given below to replace the transformer:
1.
Disengage the transformer input and the transformer output connectors,
2.
Remove the transformer screw and washer.
3.
Fix the new transformer and secure with a screw and washer.
4.
Secure the transformer input to ‘J7’ on the PWA and transformer output connector to ‘J8’
on the PWA.
7.1.23
Replacing the Cable Harness FRU (FRU Kit No. 2062276-001 for
230V, 115V and for 100V)
Illustration
NOTE: For Warmer with SMPS and LED observation lamp
Figure 100:
Replacing the Cable Harness
Summary of Contents for Lullaby Warmer
Page 12: ...This page is left blank intentionally ...
Page 139: ...LullabyTM Warmer 2042376 001 Rev G 2012 General Electric Company All rights reserved 113 ...
Page 140: ...114 2042376 001 Rev G 2012 General Electric Company All rights reserved LullabyTM Warmer ...
Page 150: ...124 2042376 001 Rev G 2012 General Electric Company All rights reserved LullabyTM Warmer ...