Performing an Exam
2-50
LOGIQ V2/LOGIQ V1
–
User Guide
Direction 5610736-100
Rev. 9
Circumference and area (ellipse) measurement
You can use an ellipse to measure circumference and area. To
measure with an ellipse:
1. Press
Measure
key to enter into measure mode, if
necessary.
2. Adjust
Caliper Change
in the Primary Menu to
Spline
.
NOTE:
The available values for
Caliper Change
menu can be set
in Utility -> Measure -> Advanced preset -> Measure Key
Sequence.
3. To position the active caliper, move the
Trackball
.
4. To fix the start point, press
Set
. The system fixes the first
caliper and displays a second active caliper.
5. To position the second caliper, move the
Trackball
.
6. Rotate
Ellipse
control on the control panel; an ellipse with
an initial circle shape displays.
7. To position the ellipse and to size the measured axes (move
the calipers), move the
Trackball
.
8. To increase or decrease the
Ellipse
, rotate the ellipse
control.
9. To toggle between active calipers, select
Cursor Select
.
10. To complete the measurement, press
Set
. The system
displays the circumference and area in the Results Window.
HINTS
Before you complete the ellipse measurement:
•
To erase the ellipse and the current data measured, press
Clear
once. The original caliper is displayed to restart the
measurement.
•
To exit the measurement function without completing the
measurement, press
Clear
a second time.
Summary of Contents for LOGIQ V2
