GE LOGIQ S7 Expert, Technical Publication

Page: 87 / 127

System maintenance
Ultrasound System
–
Common Service Information
4-9
Direction 5444964-100 English Rev. 5
Optional diagnostic checks
To complete the Ultrasound System checks, view the error logs
and run desired diagnostics.
View the logs
1. Review the Ultrasound system error log for any problems.
2. Check the temperature log to see if there are any trends that
could cause problems in the future.
Physical inspection
NOTE: These features may not be present on all Ultrasound systems.
Table 4-5: Physical checks
Step Item Description
1. Labeling Verify that all Ultrasound system labeling is present and in readable
condition.
2. Scratches & Dents Inspect the exterior for dents, scratches or cracks.
3. Covers Where applicable, verify all covers are secured in place and are properly
aligned with other covers. Replace any covers that are damaged.
4. Operating Panel Inspect alphanumeric keyboard and operator panel (operator control
panel). Record any damaged or missing items.
5. Operating Panel
Movement
• Where applicable, verify ease of operating panel (operator control panel)
movement in all acceptable directions.
• Where applicable, ensure that it latches in position as required.
6. Operating Panel
Lights
Check for proper operation of all operating panel and TGC lights.
7. LCD Inspect the LCD Display for scratches and bad pixels.
Verify proper operation of Contrast and Brightness controls.
Where applicable, confirm that the LCD arm allows:
• swivelling the screen to the left and to the right
• folding the screen to the locked position
• release and adjustment backwards and forwards
• can be adjusted in the up/down positions.
Note: LCD Arm movement may vary and is not applicable to all Ultrasound
systems.
8. Monitor Light Check for proper operation of any monitor lights, if available.
9. Input Power Refer to: ‘Mains cable inspection’ on page 4-8 .
10. External I/O Check all connectors for damage and verify that the labeling is good.